[Ok, with patch] XEmacs 21.5-b20 "cilantro" (+CVS-20050310) s parc-sun-solaris2.8
raymond.toy at ericsson.com
Wed Mar 16 17:22:01 EST 2005
>>>>> "Adrian" == Adrian Aichner <adrian at xemacs.org> writes:
Adrian> Raymond Toy <raymond.toy at ericsson.com> writes:
>> Built from a full tarball, but I grabbed a patch to make
>> src/syssignal.h be the same as the CVS version.
>> Everything seems to be ok, but it seems a quite a bit slower and more
>> consy than 21.5-b18. No hard numbers though.
Adrian> Hi Ray!
I think I should qualify the slowness a bit. It seems that gnus is
slow. I have some folders in gnus with about 1000 unread entries. It
seems b20 takes a lot longer and gc's quite a bit when getting the
Otherwise, I haven't noticed slowness anywhere else, but I don't think
my normal usage requires lots of heavy stuff to run, except gnus.
Adrian> M-x show-memory-usage
Adrian> can easily get you the data, see the bottom section of its output.
Adrian> Make sure not to disable debugging support, which also defines
I never turn off any debugging stuff on the betas. I'll send the
numbers and stuff later.
Adrian> Are you building with the exact same configuration you used for
Because I never remember how to configure xemacs, I basically copy the
config (in config.status) from previous versions. However, I did
change from gcc 3.1 to gcc 3.4.3 in this build.
Would it matter if I changed back to 3.1? Would you be interested in
More information about the XEmacs-Beta